Qlima H 408 Gebrauchsanweisung Seite 30

2. INSTALLATION
1 Do not place this machine near human body to avoid discomfort of human body;
2 Do not place this machine near wooden furniture to prevent furniture become damp
and damaged;
3 Place this machine evenly and keep distance from wall at least 30 cm to keep it run-
ning normally;
G
ATTENTION
Before use please check ultrasonic transducer first. When ultrasonic transducer is
damaged ,do not use this machine.
1 Be sure the humidifier is switched off (knob turned all the way to the left). Remove
the tank from the main housing. Bring the tank to the sink, turn upside down and
twist off the tank cap by turning counter clockwise. Fill tank with cool, fresh tap
water. DO NOT fill with warm water as this may cause leaking. Replace the cap on
tank FIRMLY. Place tank back on to the base. The tank will immediately begin to
empty into the base.
2 Connect this machine with 220-240V power socket, then it enters stand-by status. To
turn the unit on, turn the Volume Control knob clockwise, and the LED indicator
would turn to green color. Turning the knob all the way to the right will produce the
highest moisture. Turning to the left will produce lower moisture with longer run
time.
3 When the humidifier runs out of water, the LED indicator will turn to red ,the trans-
ducer and fan will automatically shut off. Once the tank is empty, turn the Power Off
and unplug the unit.
4 There is an aroma box in the mist nozzle, you can open the nozzle and put few drops
of essential oil in the sponge, then fix the nozzle. When the humidifier is turn on, the
aroma would come out together with the mist.
4
30