Disposal; Disposal Of The Appliance; Disposal Of The Packaging; Technical Data - CMi C-EXS-300 Originalbetriebsanleitung

Exzenterschleifer_450211.book Seite 35 Dienstag, 3. Dezember 2013 9:25 09
Fault/malfunction
Sanding performance insuffi-
cient.
If you are unable to correct a fault yourself,
please contact your OBI market directly.
Please note that improperly conducted
repairs will void your rights under warranty
and may cause you additional expenses.

Disposal

Disposal of the appliance

Appliances which are labelled with
the adjacent symbol must not be dis-
posed of in household waste. You
must dispose of such old electrical
and electronic equipment separately.
– Please check with your local authority
about the possibilities for correct dis-
posal.
Through separate disposal you send old
equipment for recycling or for other forms of
re-use. You will thus help to avoid in
some cases that damaging material gets into
the environment.

Disposal of the packaging

The packaging consists of card-
board and correspondingly marked
plastics that can be recycled.
– Make these materials available for recy-
cling.

Technical data

Item number
Rated voltage
Rated power
Idling speed
Cause
Sanding sheet unsuitable for
the material?
Sanding sheet worn?
Item number
Dimensions of sanding
plate
Protection class
Acoustic power (L
Acoustic pressure (L
Vibration**
Weight
*) The specified values are emission values and
do not necessarily represent safe workplace
values. Although there is a correlation between
emission and immission levels, this cannot be
used to infer whether additional safety meas-
ures are necessary or not. Factors which affect
the current immission levels at the workplace,
include the type of room, other sources of
noise, e. g. the number of machines operating
and other processes taking place in the vicinity.
Permitted workplace values can differ from
country to country. This information is designed
to help the user to better assess the dangers
and risks.
**) The specified vibration emission value was
measured in accordance with a normed test
procedure and can be used in order to compare
one tool with another. The specified vibration
emission value can also be used for an intro-
ductory evaluation of the exposure. The vibra-
tion emission value may fluctuate from the
specified value during actual use of the power
tool. These fluctuations will depend on the way
in which the power tool is used. Try to keep
vibrations to a minimum. One method of reduc-
ing the vibration load is, for example, limiting
450 211
the length of time you work with the tool. All
parts of the operating cycle must be taken into
230-240 V~,
account for this purpose (for example, also
50 Hz
including times in which the power tool is
switched off and times in which it is switched
300 W
on, but is running without load).
-1
12000 min
GB
Remedy
Replace the sanding sheet
(► Fitting the sanding sheet –
p. 33).
450 211
ø125 mm
II
)* 84,2 dB(A)
WA
(K = 3 dB(A))
)* 73,2 dB(A)
PA
(K = 3 dB(A))
< 3,041 m/s²
(K = 1,5 m/s²)
1,5 kg
35