Connecting And Charging - Braun Oral-B TRIZONE 1000 Bedienungsanleitung

• When unplugging, always hold the power plug instead of the cord.
• Use this product only for its intended use as described in this
manual. Do not use attachments which are not recommended by
the manufacturer.
• If you are undergoing treatment for any oral care condition,
consult your dental professional prior to use.
Specifications
For voltage specifications refer to the bottom of the charging unit.
Description
a Brush head
b Pressure sensor light
c On/off button (mode selection)
d Handle
e Charge indicator
f Low charge indicator light
g Basic charger
h Brush head holder (depending on model)
i Brush head compartment with protective cover (depending on
model)

Connecting and charging

Your toothbrush has a waterproof handle, is electrically safe and
designed for use in the bathroom.
• Plug the basic charger (g) or the assembled charging unit (picture
B/C) into an electrical outlet and place the toothbrush handle (d)
on the charging unit.
• The green charge indicator light (e) flashes while the handle is
being charged, once it is fully charged, the green charge indicator
light shines continuously for 5 seconds and then it turns off. A full
charge enables up to seven days of regular brushing (twice a day,
2 minutes) (picture 1).
• If the rechargeable battery is low the red low charge indicator
light (f) is flashing for some seconds when turning your toothbrush
off.
• For everyday use, the toothbrush handle can be stored on the
charging unit to maintain it at full power. Overcharging is
impossible.
• However, for environmental reasons, Oral-B recommends to
unplug the charger until the next recharge is required.
To maintain the maximum capacity of the rechargeable battery,
unplug the charging unit and fully discharge the handle with
regular use at least every 6 months.
Please note: If the charge indicator light is not flashing immediately,
continue charging. It will appear in 10–15 minutes.
Using your toothbrush
Brushing technique
This brush is designed to work with all common brushing
techniques. You can continue to use your current brushing
technique, e.g. you can brush just like you would do with a manual
toothbrush. You also may consult your dentist or dental hygienist
about the right technique for you.
We recommend the following: Wet brush head and apply toothpaste
(before switching the appliance on); you can use any kind of
toothpaste. To avoid splashing, guide the brush head to your teeth
before switching the appliance on. You start and stop brushing by
pressing the on/off button of the handle (picture 2).
Place the toothbrush bristles against the teeth at a slight angle
towards the gumline.
Apply light pressure and start brushing in back and forth motions.
Brush first the outsides, then the insides. Finally, brush the chewing
surfaces with the same back and forth motion throughout the
mouth (picture 5). Brush for 2 minutes. Please ensure that you
brush all four quadrants of your mouth equally.
Brushing modes (depending on model)
«Daily Clean» –
«Sensitive»
«Whitening»
How to switch between modes:
• When pressing the on/off button (c) your toothbrush automatically
starts in the «Daily Clean» mode.
• To switch to the «Sensitive» and «Whitening» mode, successively
press the on/off button.
• To turn off your toothbrush from the «Whitening» mode, press the
on/off button once more.
• If you wish to turn off your toothbrush from the «Daily Clean» or
«Sensitive» mode, push and hold down the on/off button until the
motor stops.
Pressure Sensor
Helping protect your teeth and gums from hard brushing, your
toothbrush has a pressure control feature installed. If too much
pressure is applied, the red pressure sensor light (b) will light
reminding you to reduce pressure (picture 3). In addition you will
also hear a different sound while brushing. Periodically check the
operation of the pressure sensor by pressing lightly on the brush
head during use.
Professional Timer
A short stuttering sound at 30-second intervals reminds you to
brush equally all four quadrants of your mouth (picture 4).
A long stuttering sound indicates the end of the professionally
recommended 2-minute brushing time. The elapsed brushing time
is memorised, even when the handle is briefly switched off during
brushing. When pausing longer than 30 seconds the timer resets.
In the first days of using any electric toothbrush, your gums may
bleed slightly. In general, bleeding should stop after a few days.
Should it persist after 2 weeks, please consult your dentist or
dental hygienist. If you have sensitive teeth and gums, Oral-B
recommends using the «Sensitive» mode (depending on model).
Oral-B brush heads feature light blue INDICATOR
you monitor brush head replacement need. With thorough brushing,
twice a day for two minutes, the blue color will fade halfway down
approximately in a 3-month period. If the bristles splay before the
color recedes, you may exert too much pressure on teeth and gums.
We do not recommend using the Oral-B FlossAction or Oral-B
3DWhite brush head with braces. You may use the Oral-B Ortho
brush head, specifically designed to clean around braces and wires.
5
Standard mode for daily mouth cleaning
– Gentle, yet thorough cleaning for sensitive
areas
– Exceptional polishing for occasional or
everyday use.
bristles to help
®