Manufacturer's Warranty - Hilti SIW 9-A22 Original Bedienungsanleitung

Trouble or fault
The power tool doesn't start.
The control switch cannot be
pressed.
Speed of rotation drops con-
siderably.
The battery is not heard to
engage.
The battery runs low more
quickly than usual.
10 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11 RoHS (Restriction of Hazardous Substances)
Click on the link to go to the table of hazardous substances: qr.hilti.com/r4838535.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
12

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
*2113608*
Printed: 18.02.2019 | Doc-Nr: PUB / 5467491 / 000 / 01
Possible cause
1 LED blinks: The battery is too hot
or too cold.
4 LEDs blink: The power tool was
overloaded briefly.
The forward / reverse selector
switch is in the middle position.
Low battery.
The retaining lugs on the battery
are dirty.
Very low ambient temperature.
2113608
Action to be taken
▶ Allow the battery to cool down
/ warm up to its working
temperature.
▶ Release the control switch and
then press it again.
▶ Push the forward / reverse
switch to the left or right.
▶ Remove the battery and charge
it.
▶ Clean the retaining lugs.
▶ Warm up the battery slowly to
room temperature.
English 21