Charging The Battery; Inserting The Battery; Removing The Battery - Hilti SIW 9-A22 Original Bedienungsanleitung

5 Preparations at the workplace
5.1

Charging the battery

1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.2

Inserting the battery

CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
5.3

Removing the battery

1. Press the release buttons on the battery.
2. Pull the battery out of its holder in the device.
5.4 Fitting the socket
CAUTION
Risk of injury through use of the wrong type of accessory tool!
▶ Use only accessory tools of the locking type.
▶ Do not use worn or damaged accessory tools.
CAUTION
Risk of injury By worn or damaged locking ring
▶ Never use a worn or damaged locking ring.
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Place the socket on the square drive spindle of the tool.
Turn the socket until the hole in the recess of the socket is in line with the hole in the square drive
spindle.
3. If the following conditions are met, also take this action:
Conditions: With O-ring and locking pin.
▶ Remove the O-ring from the groove in the socket. Insert the locking pin into the holes in the socket
and the square drive spindle. Then re-insert the O-ring in the groove in the socket.
4. If the following conditions are met, also take this action:
Conditions: With locking ring.
▶ Fit the locking ring into the socket.
5.5 Removing the socket
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Remove the locking ring or the O-ring complete with locking pin from the socket.
3. Remove the socket from the square drive spindle of the tool.
18 English
Printed: 18.02.2019 | Doc-Nr: PUB / 5467491 / 000 / 01
2
3
2113608
*2113608*