Technical Data - Hilti SIW 9-A22 Original Bedienungsanleitung

Status
1 LED lights.
1 LED blinks, the power tool is ready for use.
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Battery charge state cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the battery display LEDs blink, please observe the instructions
given in the Troubleshooting section.
4

Technical data

4.1 Impact wrench
Rated voltage
Weight in accordance with EPTA procedure 01
Rated speed under no load
Impact frequency
Ambient temperature for operation
Storage temperature
4.2 Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
4.3 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the power tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: Maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
Noise emission values
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Sound power level (L
WA
Uncertainty for the sound power level (K
Total vibration
Vibration emission value when tightening screws/bolts and nuts of the
maximum permitted size (a
Uncertainty (K)
*2113608*
Printed: 18.02.2019 | Doc-Nr: PUB / 5467491 / 000 / 01
)
pA
)
pA
)
)
WA
)
h
2113608
Meaning
State of charge: 10 % to 25 %
State of charge: < 10 %
The battery has overheated.
The power tool is overloaded or has overheated.
21.6 V
DC
3.6 kg
1,400 /min
2,200 bpm
−17 ℃ ... 60 ℃
−20 ℃ ... 70 ℃
21.6 V
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
98.5 dB(A)
3 dB(A)
109.5 dB(A)
3 dB(A)
7 m/s²
1.5 m/s²
English 17