Herth+Buss Quicky 90A Anleitung Seite 32

Operating Instructions
NOTE: When charging a battery that is not
marked, check the manual of the item which
EN
uses the battery for the correct battery type.
Make sure the battery complies with the
safety instructions in Section 3.3.
Digital Display
The Digital Display gives a digital indication of
voltage, % of charge or time. The display will
show the battery VOLTAGE when the charger
is not charging a battery. When it goes into
charging mode, the display will automatically
change to ON (to show charging has started)
and then show the percent-of-charge of the
battery being charged and either 6 or 12 (the
voltage the charger determined the battery
is). If you manually stop the charging pro-
cess (by pressing the CHARGE RATE button)
before the battery is fully charged the display
will show OFF .
Battery % – The digital display shows
an estimated charge percentage of the
battery connected to the charger battery
clips.
Voltage – The digital display shows the
voltage at the charger battery clips in DC
volts.
www.herthundbuss.com
NOTE
Once the charger has started charging
the battery; if you press the Charge Rate
button once, the output current is shut
off and the display with show OFF and
then the battery voltage. If you press the
Charge Rate button again, the current
will go back on at the same setting it was
when it was turned off. For example:
The charger is charging a battery at the
slow charge rate setting. If you press the
Charge Rate button, the output is turned
off. If you press the Charge Rate button
again, the output will turn back on at the
slow charge rate setting.
95950003
32