Connecting The Temperature Sensor (14); Selecting The Temperature Unit; Getting Started - FLORABEST FFGT 433 A1 Bedienungsanleitung Und Sicherheitshinweise

FLORABEST FFGT 433 A1

Insert two AAA 1.5V (Micro/R03/LR3) batteries,
making sure the polarity is correct. Refer to the
diagram inside the battery compartment (10).

Close the battery compartment (10) by replacing
the cover (8) and pushing it upwards in the
opposite direction to the arrow.

Now fit the belt clip (9) by placing it on the open
side of the guide and pushing it to the right until it
clicks into place.

7.2 Connecting the temperature sensor (14)

Insert the connector (15) into the socket (16) on the side
of the transmitter (13). When not in use, the temperature
sensor (14) can be stored in the holder next to the
socket (16).

7.3 Selecting the temperature unit

You can choose between two temperature units (°C
and °F). Slide the selector switch (11) in the battery
compartment (10) to the desired position.

8. Getting started


Switch the transmitter (13) on by sliding the
ON/OFF switch (18) to the "ON" position. When
in use, the red LED (17) flashes about every 4
seconds.

Now switch the receiver (1) on too by moving the
ON/OFF switch (12) to the "ON" position. A
signal sounds and the LCD display (2) lights up
once briefly with blue back-lighting, then red and
then blue again.
If the temperature sensor (14) is not
connected to the transmitter (13) or there is a
fault with the wireless connection between the
transmitter (13) and the receiver (1), "- - -" is
displayed as the current temperature on the
LCD display (2).
In this case, make sure the connector (15) is
inserted correctly into the socket (16) and that
the distance between the transmitter (13) and
the receiver (1) is not too great. If necessary,
switch the transmitter (13) and receiver (1) off
for about 3 seconds and then switch them
back on again. This should resolve the
problem.
26 - English