Setting Color Temperature; Synchronous Control Of Several Led Lights; Battery Charging Indicator - walser Walimex Pro Flex LED series Gebrauchsanleitung

8.3 Setting color temperature

The currently selected color temperature in Kelvin is displayed on the display (10)
1. To adjust the color temperature, tap the arrows up or down to change the
desired values
2. The range of color temperature can be set from 3000 to 5600 Kelvin
3. After pressing the arrow keys on the display, the new value is automatically
accepted and shown on the display immediately

8.4 Synchronous control of several led lights

The lights of the walimex pro Flex LED series 500 and 1000 can be connected
wirelessly in order to be able to control the values for the color temperature and
the brightness synchronously.
1. Screw the antenna (12) to the antenna port (11) of the control unit.
2. Switch on all the devices to be controlled.
3. The display shows the currently selected channel next to the channel
symbol <CH>.
4. The following channel settings can be selected:
OFF / A / B / C / D
6. Select the desired channel by tapping the <CH> symbol on the touch
screen.
7. After pressing the button, the new value is automatically accepted and dis-
played immediately.
8. Set the same channels on all the lights that are provided for synchronization.
9 The synchronization of all lights with the same channel settings are made
through the first change of a value for the color temperature or brightness.
10. To do this, tap the corresponding arrow keys and change a value.
11. Set the desired brightness and color temperature values.
12. Now the values of the synchronized devices are adjusted and all connec-
ted lights can be controlled via any control unit.

8.5 Battery Charging indicator

The device must be equipped with a sufficiently charged battery for operation.
The control unit has a charge control indicator for the used battery. If the inser-
ted battery is too much discharged, the control unit does not function in the bat-
tery operation mode. Charge the battery before use in the led light and note the
instructions for use. When operating with cable power (switch position <II>),
a full battery status is indicated in the display. The display does not show the
correct, actual battery charge status during cable operation mode. The correct
battery charge indicator function is generally only available when the battery
mode is selected (switch is set to <I>) and the battery is sufficiently charged.
33