Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Then insert the light mat including brackets into a suitable lamp stand or a
suitable ceiling mount (5/8 inch) spigot holder.
• Set the desired tilt angle of the bracket
• T ighten all 3 screws on the lamp holder firmly and securely after the final
alignment of the bracket
6.2 Mounting the power adapter holder to the V-mount battery holder
You can use the built-in V-mount battery slot on the control unit (7) as a holder
for the power adapter (17). Supplied for this purpose a corresponding holder
with velcro tape (19) is included in the scope of delivery.
• W rap this bracket included velcro straps firmly and tightly around the AC
adapter and close the velcro strap
• From the rear, slide the power adapter, including the mounting frame, from
the left to the right into the V-mount battery slot (15) of the control unit (7)
• A click of the battery lock (16) usually signals the save locking of the power
adapter holder
• To remove the holder again, press the battery release button (16) and remo-
ve the power adapter by pulling it out to the left
Note
Alternatively, on this devices, you can attach the power adapter units with
the supplied velcro fastening straps. Make sure that the power adapter units
are not attached too tightly. If the power adapter unit is not secured with ad-
ditional means, constant pressure will be exerted on the XLR power connec-
tion plug. This leads to wear and can damage the socket. We strongly re-
commend the usage of the ac adapter frames in the v-mount holders for
cable usage.
29
Werbung
Inhaltsverzeichnis
