Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. Prepare the device for use
7.1 Mounting and connecting the battery
The walimex pro Flex LED lights are equipped with a Sony V-Mount / Anton
Bauer compatible battery slot. The device can be operated either by battery
or cable power. The battery slot is located on the back side of the power
control unit.
• Set the ON / OFF switch on the control
unit (7) to the <0> position to switch off
the device.
• I nsert a sufficiently charged, compatible
battery from left to right into the battery
slot (15).
• A click of the battery lock (16) usually
signals the save locking of battery.
• Set the ON / OFF switch on the control
unit (7) to the <I> position to set the
battery operation mode on the unit.
• The unit is ready for battery operation.
• To remove the battery, press the unlock
button (16) of the battery slot and remove
the battery by pulling it out to the left.
Note
The device must be equipped with a sufficiently charged battery for operation.
The control unit has a charge control indicator for the used battery. If the inserted
battery is too much discharged, the control unit does not function in the battery
operation mode. Charge the battery before use in the led light and note the inst-
ructions for use. When operating with cable power (switch position <II>), a full bat-
tery status is indicated in the display. The display does not show the correct, actual
battery charge status during cable operation mode. The correct battery charge
indicator function is generally only available when the battery mode is selected
(switch is set to <I>) and the battery is sufficiently charged.
30
Werbung
Inhaltsverzeichnis
