Herunterladen Inhalt Inhalt Diese Seite drucken

walser Walimex Pro Flex LED series Gebrauchsanleitung Seite 25

Flächenleuchten
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

WARNING
Danger of electric shock, burn hazard
Please note, that the device is still connected with the supply voltage even
if it is switched off. Just after disconnecting the device from the power sup-
ply through pulling out the power cable, the device is actually de-energized.
■ Switch off your device when it is not in use.
■ Switch off your device before mounting and maintenance and dis-
connect from power supply.
■ Protect your device against unintended switching-on.
■ Unplug the power cord, if the flash is not in use for a long time.
WARNING
Danger of electric shock, fire through short-circuit
A short-circuit could be caused through defect cables and through humidity
or moisture. A short-circuit can warm up the conductors, so that there isola-
tion will melt or even melt thoroughly. This could lead to fire.
■ Please just use the original cables, which are included in delivery. They
are aligned for your device and guarantee the necessary safety for you
and your device.
■ Don´t operate the device with wet hands or feet.
■ Operate the device only in dry rooms.
■ Don´t operate the device outdoors.
■ Please only follow this instruction manual for cleaning your device.
■ Make sure, that cables and conductors won´t be damaged. Damages
could be caused through heat impact, chemical influence or through
mechanical impacts as rubbing, bending, tearing, rolling over or nibbling
animals.
■ Prevent your device for falling-off. In case of falling-off, please let an
electrician check the device before switching on again.
■ If your device should be damaged or defect or if you notice a burning
smell:
Disconnect the power supply by pulling out the power cord. Never
operate your device with damaged housing, damaged reflector, defect
modeling lamp, defect flash tube or damaged power cord. Don´t open
the device. Never repair the device on your own. The device should
only be repaired by electricians.
■ Please follow this instruction manual for maintaining your device.
■ Please just use spare parts, which are conform to the required specifi-
cations.
■ Illuminants must only be replaced by a skilled electrician.
24

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis