Operating The Device, Settings And Display Signals; Switching The Device On / Off - Setting Power Source; Setting Brightness (Dimmer Function); Setting Color Temperature - walser Walimex Pro Flex LED series Gebrauchsanleitung

8. Operating the device, Settings and Display signals

The control unit of the walimex pro Flex LED light is equipped with a touch
display to show the selected settings and to control the device.
8.1 Switching the device on / off - setting power source
1. Connect the power supply to the power control unit as described in section
7 using the power cable or battery.
2. Select the desired power source with the ON / OFF switch (14) of the
control unit (7).
<0> OFF
<I> Battery operation mode
<II> AC cable power operation mode
3. The display lights up and shows the current settings for the brightness,
the color temperature and the selected channel.
4. The device is ready for use.

8.2 Setting brightness (dimmer function)

The currently selected light intensity is shown in % on the display (10)
1. To adjust the brightness, tap the arrows up or down to change the desired
brightness
2. Tap the arrows to set the values upwards or down
3. The brightness can be adjusted continuously from 0 to 100%
4. After pressing the arrow keys on the display, the new value is automatically
accepted and shown on the display immediately

8.3 Setting color temperature

The currently selected color temperature in Kelvin is displayed on the display (10)
1. To adjust the color temperature, tap the arrows up or down to change the
desired values
2. The range of color temperature can be set from 3000 to 5600 Kelvin
3. After pressing the arrow keys on the display, the new value is automatically
accepted and shown on the display immediately
32