Preparing The Device For Use, Connection For Cable Operation Mode - walser Walimex Pro Flex LED series Gebrauchsanleitung

Recommendations for using your battery
• Change the battery, at the latest, when the light starts to flicker.
• Switch the device off before removing the battery.
• This also applies for changing or adding another battery in models with
several battery mounts. Switch the light off before adding or changing the
battery, and do not insert other batteries into the mount while the light is
being used.
• Do not let the battery charge level go too low, and charge up your battery
as soon as possible. This ensures the longer battery life.
• Please remove the battery from the battery mount while transporting or
storing the device. This is to prevent damage to the battery mounts during
transportation and prevents the battery becoming uncharged unintentio-
nally.
• To maintain the performance of your battery, we recommend letting the
battery run down completely and then recharging it around once a month.
• Please remove the battery from its mount after using your device.

7.2 Preparing the device for use, connection for cable operation mode

1. Set the ON / OFF switch on the control unit (7) to the <0> position to switch
off the device.
2. Connect the power cable of the light mat (2) to the connection cable of the
power control unit (7).
3. Connect the XLR plug of the power supply unit (17) to the power supply
socket of the control unit (13).
4. A click indicates the lock of the safety lever of the XLR connector of the
power supply.
5. Connect the power cable to the power adapter.
6. Connect the power cable with the power adapter (AC 220-240V / 50Hz).
7. Set the ON / OFF switch on the power control unit (7) to the <II> position to
set the cable power mode.
8. The LED panel light is now ready for use.
9. Procedure of the power supply in reverse order for removal.
31