5. Quick reference guide
Note
Detailed instructions for the following activities can be found in the relevant
sections of these instructions for use. Strictly follow the sequence of the
following activities during first time use, to prevent damage to the device.
WARNING
With any action you take you should pay attention to the safety notes in the
corresponding paragraphs.
6. Preparing the device for use
The lights of the walimex pro Flex LED series can be operated by its special
construction with or without bracket. It should be noted that no control ele-
ments are installed on the light mat itself. The device is operated exclusively
via the control and power unit (7).
6.1 Fitting the light mat into the holder, mounting on a stand
For use as a classical light panel on a light stand, we first recommend the ins-
tallation of the lighting mat in the X-frame holder (4). After that the preparation
of the power supply.
• Spread the braces of the X-frame (4)
• Place the light mat with the black side upwards on a clean and dry storage
space
• Slide the braces of the bracket (1) at the corners (5) of the light mat at one
of the shorter sides.
• Slide 2 of the 4 braces of the x-frame stand holder (4) into the edge holder
brackets (5) of the shorter sides of the lightning mat.
• Then, individually insert the remaining spreads into all remaining corners of
the lightning mat.
• Avoid excessive pressure and damage to the braces and light-emitting mat
corners.
• Connect the x-frame holding bracket with the bendable stand mount (6) and
secure the installed screws.
28