Installation And Connection - Oase PondoVac 5 Gebrauchsanleitung

Downloaded from www.watergardeningdirect.com
- EN -

Installation and connection

 G
Attention! Dangerous electrical voltage.
Possible consequences: Death or serious injuries due to operation of electrical units or installations in or
near ponds/pools.
Protective measures:
 Set up the unit at least 2 m away from the pond/pool.
 Ensure that the ground under the unit is firm and horizontal so that the unit cannot tip over.
Note!
The vacuum cleaner can be set up and operated in a position that is up to 0.5 m lower than the water level.
Possible consequences:
 When the vacuum cleaner is switched off, the water will automatically flow through the tank while the suc-
tion hose remains in the pond/pool. The pond/pool will be emptied.
Remedy:
 Always take the suction hose out of the pool/pond when the vacuum cleaner is switched off.
Adjusting the transport brace
How to proceed:
 H
1. Undo the locking screw.
2. Move the transport brace into the desired position.
3. Hand-tighten the locking screw.
Connecting the hoses and nozzles
How to proceed:
 I
1. Attach the discharge hose to the outlet and twist it clockwise (bayonet closure).
– If only coarse dirt particles >1 mm (e.g. leaves or hair) are to be removed, you can allow the waste water to flow
back into the pond / pool via the fine filter bag.
– Do not allow muddy water to flow back into the pond / pool.
2. Attach the suction hose to the inlet.
3. Fit extension tubes and the desired nozzle to the suction hose with handle.
– Universal nozzle: For removing pond sludge without vacuuming up the pond gravel.
– Algae nozzle: For separating and removing string algae.
– Brush nozzle: For removing stubborn dirt.
– Surface cleaning nozzle: For cleaning large, smooth surfaces.
– Wet suction nozzle: For removing dirty or residual water for operation as a wet vacuum cleaner
Note!
 The more tubes that are used, the higher the tube frictional resistance. This leads to a reduction of the
suction capacity.
 Set up the vacuum cleaner on ground that is not much higher than the water level so as not to impair the
suction capacity.
The following conditions must be met:
 Allow the dirty water to drain out into a drain or far enough away from the pond to ensure that it cannot flow back
into the pond.
 Completely unwind the power and extension cable.
– Ensure that the cables are not bundled together or coiled up.
20