Installation And Connection - Oase Vitronic 11W Gebrauchsanleitung

- GB -
Correct electrical installation
− Electrical installations must meet the national regulations and may only be carried out by a qualified electrician.
− A person is regarded as a qualified electrician, if, due to his/her vocational education, knowledge and experience, he
or she is capable of and authorised to judge and carry out the work commissioned to him/her. Working as a qualified
person also includes the recognition of possible hazards and the adherence to the pertinent regional and national
standards, rules and regulations.
− For your own safety, please consult a qualified electrician.
− The unit may only be connected when the electrical data of the unit and the power supply coincide. The unit data is
to be found on the unit type plate or on the packaging, or in this manual.
− Ensure that the unit is fused for a rated fault current of max. 30 mA by means of a fault current protection device.
− Extension cables and power distributors (e.g. outlet strips) must be suitable for outdoor use.
− Minimum safety distance between the unit and the water: 2 m.
− Ensure that the power connection cable cross section is not smaller than that of the rubber sheath with the
identification H05RN-F. Extension cables must meet DIN VDE 0620.
− Protect the plug connections from moisture.
− Only plug the unit into a correctly fitted socket.
Safe operation
− Never operate the unit if either the electrical cables or the housing are defective!
− Do not carry or pull the unit by its electrical cable.
− Route all cables such that damage is excluded and nobody can trip over them.
− Never open the unit housing or its attendant components, unless this is explicitly required in the operating
instructions.
− Only use original spare parts and accessories for the unit.
− Never carry out technical modifications to the unit.
− Only have repairs carried out by customer service points authorised by OASE.
− The power connection cables cannot be replaced. When the cable is damaged, the unit or the component needs to
be disposed of.
− Only operate the unit if no persons are in the water!
− The unit, the connections and plugs are not water-proof and must not be routed or installed in water.
− Keep the socket and power plug dry.

Installation and connection

Attention! Dangerous electrical voltage.
Possible consequences: Death or serious injuries.
Protective measures:
− Only operate the unit with the protection hood fitted.
− Ensure that the unit is installed water-tight with a safety distance from the water of a minimum of 2 m.
Set-up the unit
Figure A-C:
Vitronic 11: Turn the unit head (2) counter-clockwise against the stop, then carefully pull out of the housing (1).
Vitronic 18, 36, 55: In the housing (1), the unit head (2) is fastened by means of a bayonet closure. Press on the
engagement lug at the housing (1), turn the unit head (2) counter-clockwise and carefully pull it out of the housing (1).
Place the unit horizontally with its feet down, and fasten with two screws. Other installation positions are not permissi-
ble!
10