Electrolux SL Series Bedienungsanleitung Seite 38

Interval function by controls:
e → , , ... →
Keep pressing at the same time the push
button and
speed will switch on, press again the push
button , the light indicator will show the
following for the speeds of the motor
2→3→1→2→3 ...;
Keep pressing within 5 seconds the push
button and
the motor you wish for the interval function.
Setting of the interval function by the remote control:
→ , , ... →
Press the push button
button the light indicator will show the following for the speeds of the motor 2→3→1→2→3
...;
Press within 5 seconds the
the interval function.
By pressing any push button, light excluded, the interval function is excluded.
The remote control has a battery (type 23 A). When the battery is exhausted you need to:
loosen the 2 screws on the rear part and remove the cover; take the battery out and replace it
with one with the same characteristics.
Close the cover again and tighten the screws.
Follow National norms for waste disposal of exhausted batteries.
SATURATION INDICATORS OF GREASE FILTERS AND CARBON FILTERS
The hood is delivered standard in suction use: if you wish to use the hood in filtering
version it is necessary to set this function.
When the grease filters need to be cleaned, you have a saturation indicator for the grease
filters and, if the hood is set for filtering use, when the carbon filters need to be
replaced/regenerated you have a saturation indicator for the carbon filters.
Saturation indicator alarm for the grease filter: acoustic signal with working motor and the point
of the led of the push button
Clearing the saturation indicator alarm for the grease filter: with the motor off press twice the
push button.
Saturation indicator alarm for the carbon filters: acoustic signal with working motor and led of
the push button is flashing.
Clearing of the saturation indicator alarm of the carbon filter: press twice the
38
e
: the led point of the first
to confirm the speed for
: the light indicator will show first speed, press again the
push button to confirm the speed for the motor you wish for
is flashing.
e / / →
Keep pressing at the same time the push
button and one of the speeds
at which you wish to set the interval function.
That is
Press and for the first speeed
Press and
for the second speeed
Press and for the third speeed
Press within 5 seconds the
confirm the speed for the motor you wish for
the interval function.
/ /
push button to
push
push button.