Setting And Starting A Programme; Setting Mode - Electrolux GA60LI221 Benutzerinformation

58 www.electrolux.com
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to 'SET-
TING AND STARTING A PRO-
GRAMME'.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
7.1 Using the detergent
A
7.2 Setting and starting a
programme

Setting mode

The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when,
after the activation:
• All the programme indicators come on
• The display shows 2 horizontal status
bars.
If the control panel shows other condi-
tions, press the cancel button until the ap-
pliance is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. To set a programme, keep the appli-
ance door ajar.
3. Press the on/off button to activate the
appliance.
4. Make sure that the appliance is in set-
ting mode.
5. Press one of the programme buttons
again and again until only the indicator
B
30
A
20
-
+
C
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme
for the type of load and the degree of
soil.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
of the programme that you want to set
is on.
• The programme duration flashes in
the display.
6. If you want, you can set the options.
7. Close the appliance door. The pro-
gramme starts.
• The display shows the programme
duration that decreases with steps
of 1 minute.
Starting a programme with delay
start
1. Set the programme and the options.
2. Press the delay button again and
again until the display shows the delay
time you want to set (from 1 to 24
hours).
• The delay time flashes in the dis-
play.
3. Close the appliance door. The count-
down starts.
• The display shows the countdown
of the delay start that decreases
with steps of 1 hour.
• When the countdown is completed, the
programme starts.