General Information; Designated Use - Becker Centronic VarioControl VC420 Bedienungsanleitung

Operating Instructions
The VC420, as delivered ex works, converts radio signals into control signals and
can be used to control a mains-connected drive
The VC420 may be used to operate roller shutter, awning and venetian blind sys-
tems only.
This device may only be used in connection with equipment from other manufac-
turers following consultation with your local retailer.
• Please note that radio sets cannot be operated in areas with increased risk of
interference (e.g. hospitals, airports).
• The remote control is only permitted for equipment and systems with which a
malfunction in the hand-held transmitter or receiver does not present a risk to
persons, animals or objects, or this risk is covered by other safety devices.
• The operator does not enjoy any protection from disturbances by other remote
signalling equipment and terminal equipment (for example, also by radio sets
operated in the same frequency range in accordance with regulations).
• Use radio receivers in conjunction only with devices and systems permitted by
the manufacturer.
Note
Ensure that the controls are not installed and operated in the vicinity of
metal surfaces or magnetic fields.
Radio sets transmitting at the same frequency could interfere with recep-
tion.
It should be noted that the range of the radio signal is restricted by legis-
lation and constructional measures.

General information

Designated use

15