Safety Instructions - Klarstein Skyscraper 2G Bedienungsanleitung

EN
10

SAFETY INSTRUCTIONS

• Remove the packaging and make sure that the appliance is intact. If in doubt, do
not use it and contact qualified personnel only.
• Packaging materials (plastic bags, polystyrene, staples etc.) Must be kept out of the
reach of children as they could be hazardous.
• This appliance can be used by children aged from 8 years and above and people
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children should
be supervised to ensure that they do not play with the appliance. Cleaning and
maintenance operations must not be performed by children without supervision
• Before connecting the appliance, check that the appliance rating corresponds to
the mains rating.
• This appliance must only be used for the purpose for which it has been
manufactured. As a stand fan. The manufacturer is not responsible for any damage
caused by improper or incorrect use.
• The installation/assembly of the device will be made according to the indications of
the manufacturer. A wrong procedure may cause damages to persons, animals or
objects, for which the manufacturer cannot be considered responsible
• Before cleaning or carrying out maintenance on the appliance, disconnect it from
the electrical mains by removing the plug from the electrical outlet or by switching
off the system switch.
• If the appliance is faulty and/or operating incorrectly, switch it off without
tampering with it. If the above is disregarded, the safety of the appliance may be
compromised.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
• Do not power the device using multiple sockets.
• Do not use adapters and/or extension cable
• The device must not be switched on using external timers and/or other remote
control devices which are not specified in this manual.
• Do not use or store the device near heat sources (heaters, stoves).
• Do not dip the device in water or other liquids; in case the accidental fall in the
water do not try to take it out, but first of all unplug immediately the power cable
from the socket.
• If you use the device for the first time, make sure to remove any label or protective
sheet which blocks its proper functioning.
• Plug and unplug the power cable with dry hands and hold it firmly.
• Before plugging the plug into a wall outlet, make sure that the unit is switched off.
• Always unplug the power cable to avoid the overheating and avoid stretching it.
• Make sure that all air intakes and outlets are free and not covered so that the unit
does not overheat.
• Avoid placing the power cable on abrasive or sharp surfaces or in positions where
it can be damaged easily.