EN
12
SAFETY INSTRUCTIONS
•
Remove the packaging and make sure that the appliance is intact. If in doubt,
do not use it and contact qualified personnel only.
•
Packaging materials (plastic bags, polystyrene, staples etc.) Must be kept out
of the reach of children as they could be hazardous.
•
This device may be only used by children 8 years old or older and persons with
limited physical, sensory and mental capabilities and / or lack of experience
and knowledge, provided that they have been instructed in use of the device
by a responsible person who understands the associated risks.
•
Before connecting the appliance, check that the appliance rating corresponds
to the mains rating.
•
This appliance must only be used for the purpose for which it has been
manufactured. As a stand fan. The manufacturer is not responsible for any
damage caused by improper or incorrect use.
•
The installation/assembly of the device will be made according to the
indications of the manufacturer. A wrong procedure may cause damages to
persons, animals or objects, for which the manufacturer cannot be considered
responsible
•
Before cleaning or carrying out maintenance on the appliance, disconnect it
from the electrical mains by removing the plug from the electrical outlet or by
switching off the system switch.
•
If the appliance is faulty and/or operating incorrectly, switch it off without
tampering with it. If the above is disregarded, the safety of the appliance may
be compromised.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
•
Do not power the device using multiple sockets.
•
Do not use adapters and/or extension cable
•
The device must not be switched on using external timers and/or other
remote control devices which are not specified in this manual.
•
Do not use or store the device near heat sources (heaters, stoves).
•
Do not dip the device in water or other liquids; in case the accidental fall in the
water do not try to take it out, but first of all unplug immediately the power
cable from the socket.
•
If you use the device for the first time, make sure to remove any label or
protective sheet which blocks its proper functioning.
•
Plug and unplug the power cable with dry hands and hold it firmly.
•
Before plugging the plug into a wall outlet, make sure that the unit is switched
off.
•
Always unplug the power cable to avoid the overheating and avoid stretching
it.
•
Make sure that all air intakes and outlets are free and not covered so that the
unit does not overheat.
•
Avoid placing the power cable on abrasive or sharp surfaces or in positions
where it can be damaged easily.