Original Accessories/Auxiliary Equipment; Information On Saw Blades; Before Use; Charging The Battery Pack (See Fig. A) - Parkside PSTDA 20-Li A1 Originalbetriebsanleitung

Original accessories/auxiliary
equipment
■ Use only the accessories and additional
equipment that are specified in the operat-
ing instructions and are compatible with
the appliance.

Information on saw blades

The Parkside basic equipment includes saw blades
for use with wood and metal.
▯ 2 saw blades for general wood cutting
▯ 1 saw blade for light metals up to 5 mm
NOTE
► You can use any saw blade, provided it is
fitted with a suitable mounting (single-lug
shank).
Saw blade type
suitable
■ 18 │ GB

Before use

Charging the battery pack (see fig. A)
♦
unsuitable
♦
♦
♦
■
♦
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The storage climate
should be cool and dry and the ambient
temperature should be between 0°C and
50°C.
Connect the battery pack
battery charger (see fig. A).
Insert the power plug into the socket. The control
LED lights up red.
The green LED indicates that the charging
process is complete and the battery pack
is ready.
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged.
♦ If the red and green control LEDs
flash, this means that the battery pack
broken.
Push the battery pack
ance.
Never recharge a battery pack again im-
mediately after rapid charging. There is a risk
that the battery pack will overheat and this will
reduce the lifespan of the battery.
Switch off the charger for at least 15 minutes
between successive charging sessions.
To do this, disconnect the power plug.
to the high-speed
flashes, this means
has overheated and
both
is
back into the appli-
PSTDA 20-Li A1