Painting; Disassembling; Technical Hints - Revox Re:sound I IWS 51 Bedienungsanleitung

IWS + ICS
Adjusting speaker colour
Painting the speaker grille
You should remove the internal
fleece first, if the grill also is to be
painted. The fleece has an adhesive
surface, which allows you to put the
fleece back in position once the
paint has dried.
If the fleece does not adhere any
more, you can use a standard spray
adhesive.

Disassembling

Hold the speaker in position and
unscrew the four fixing screws until
the head of the screw protrudes by
about 1 mm. The four rotary
tensioners are now back in the
install position and the speaker can
be removed.

Technical hints

Cable lengths
In order to keep the line and treble
loss as low as possible, we
recommend that
following cable profiles and in any
case, you should use 2-core wire.
Up to 15 m:
Up to 30 m:
Over 30 m:
Up to 50 ft:
Up to 100 ft:
Over 100 ft:
We advise that you avoid using
cable lengths above 50 metres, in
order to avoid
reproduction.
Load capacity
It is possible to operate these
speakers with amplifiers that have a
higher output performance. In this
case however, you must ensure that
the volume is only turned up to a
level where your ear (usually a
reliable measure) starts to notice an
overload.
Your Revox speakers will not be
damaged by a short-term overload.
11
Re:sound I
you use the
2
Ø 0.75 mm
2
Ø 1.50 mm
2
Ø 2.50 mm
AWG 17
AWG 14
AWG 12
loss of hi-fi