Iws65 Colour Matching; Painting The Iws65 Frame; Repainting The Speaker Grille; Installation In Inwall Back Box - Revox IWS65 Anleitung

IWS 65
Colour matching the IWS65

Painting the IWS65 frame

Using the painting template
supplied, the IWS65 can be
colour matched to its location.
Remove the speaker grille and
fix the painting template to the
speaker at the same position.
Make sure that no paint spray
mist can get into the side of the
speaker.

Repainting the speaker grille

If you also want to repaint the
speaker grille, you should
remove the foam from inside
first. The foam is glued on one
side so that you can re-position it
once the paint has dried.
You will find further information
about the speaker cables and
the connections on page 21,
Technical Details.
19
Installation in the
Inwall Back Box
REVOX
(optional; Part. No. 1.084.472.01)
If the housing is being installed
during the building phase, we
recommend that you use the
corresponding, watertight Inwall
Back Box. This can either be
inserted into the wall at the
preliminary building phase (Fig. 1)
or fixed to the building shell
when the walls or ceiling are
being sealed (Fig. 2).
! Please note the positioning !
The positioning of the
speaker cannot be corrected
later. Before installing the
Inwall Back Box, check the
speaker position by reference
to the corresponding label
inside the housing.

Speaker cabling

There is a round hole on each
side of the Inwall Back Box with
a plastic sleeve where you can
fit 20mm ( 0.79 in) cabling
tubing (EN20 Flexduct).
These should be used for the
ducting for the speaker cabling.
You must ensure that the joint
between the housing and the
ducting is completely tight and
that no cement can find its way
in during sealing.