Cleaning And Maintenance - oneConcept Cleanfox Bedienungsanleitung

2. Use
CAUTION: Do not leave the appliance without supervision during operation, so you can interfere if it is
obstructed by furniture/objects.Switch the appliance immediately off if something gets stuck in the
nozzle and remove the obstruction.
a. Ensure that the dust container is empty, attached, and free of dirt (see chapter "Cleaning and
Maintenance").
b. Place the appliance in the center of the room to be cleaned.
c. Set the On/Off switch to position I to switch the appliance on. The appliance starts cleaning the
floor. The green and red status indicators are flashing in turn. The appliance changes direction upon
touching an obstruction.
d. The appliance cleans the floor until it is switched off (On/Off switch in position O) or the battery is
exhausted. The flashing red status indicator signals an empty battery. Charge the battery as
described in chapter "Charge the Battery".
e. Empty the dust container after every use and remove dirt as described in the following chapter.
WARNING: Always disconnect the device from the power adaptor before cleaning! Do not submerge the
device in water. Only the dust container and the filter can be rinsed off.
CAUTION: Do not use a wire brush or other abrasives for cleaning. Do not use aggressive or abrasive
cleaning agents.

Clean the casing with a dry cloth.

Ensure before and after each use that the nozzle and the ventilation openings are clean.

For best performance, you should empty the dust container and clean the filter after every use.
1. Empty the Dust Container and Clean the Filter
CAUTION: Replace all parts only when they are completely dry! Do not wash the filters in the washing
machine and do no use a hair dryer.
NOTE: Use a brush to clean the filter.
a. Press the two unlock buttons (3) of the dust container down to loosen the dust container.
b. Lift the dust container out of the appliance.
c. Carefully remove the dust container cover. Slightly pull one of the locks on the side slightly away
from the dust container to unlock the cover.
d. Hold the dust container over a dustbin and remove the filter.
e. Empty the container into the dustbin and carefully beat or brush off the filter.
f. Both components can be cleaned under running water. They must be completely dry before being
replaced.
g. Brush out the container compartment in the appliance before replacing the dust container. Turn the
appliance upside down and brush off the nozzles and the bottom of the appliance. Wipe the casing
with a dry or slightly damp cloth.
h. Replace the filter in the dust container (the plastic grid must be aligned upward).
i. Replace the dust container in the appliance so that it clicks into place.
2. Clean/Replace the Floor Cloth
Over time, dirt can collect on the floor cloth. You can clean or replace the floor cloth.
a. Turn the appliance upside down and place it on the floor or on a table.
b. The floor cloth is attached to a plastic holder (16). It is attached to the appliance on the left and
right sides next to the drive wheels (14) and (17). Take the narrow end piece of the holder between

Cleaning and Maintenance