Charging The Battery - oneConcept Cleanfox Bedienungsanleitung

1. Connect the Battery
a. Ensure that the appliance is not connected to mains power.
b. Open the battery compartment: Slightly press the lid down and lift it up.
c. Insert the battery cable plug into the jack inside the battery compartment.
d. Close the battery compartment.

3. Charging the Battery

a. The adaptor jack (10) is next to the On/Off switch (1).
b. Lift the jack cover and connect the adaptor cable.
c. Connect the adaptor's mains plug to a freely accessible wall outlet.
d. Charging starts. The green status indicator (4) starts flashing.
e. The green status indicator (4) lights up as soon as the battery is fully charged. Disconnect the
appliance from mains power and close the cover.
f. Your appliance is now ready to use.
NOTE: Charging takes 12 hours before first use and 6 hours for following charges.
1. Prepare the Room
CAUTION: Observe the appliance if you are using it in a room, to remove obstructions, if necessary, so
that the appliance effectively can clean the entire room. The appliance is not suitable for plush/deep pile
carpeting.
a. Ensure that your floor is free of objects which could be caught in the nozzle or which could obstruct
the appliance during cleaning. Especially, leave no plastic bags lying on the floor.
b. Ensure that the appliance cannot come into contact with cables, cords or fringes of curtains, table
cloths, or carpets. Fold carpet fringes under the carpet.
c. Remove all objects which could tip over (e.g. vases, small lamps, decorations).
d. The distance between two objects (e.g. wall and shelf) must be at least 40 cm for the appliance to
fit through.
e. The appliance can get stuck under furniture, which is just high enough off the floor. Block the way,
for instance with pot plants, which are heavy enough not to be tipped over
Start-up
Operating