Troubleshooting; Specifications - oneConcept Cleanfox Bedienungsanleitung

your fingers and pull it outward towards the drive wheel until it comes free. Now you can remove
the holder from the appliance.
c. Turn the holder around and pull the cloth out of the 4 clips.
d. Now you can wash it in lukewarm water and a mild detergent. The supplied cloths are not suitable
for the washing machine! Leave the cloth to dry completely before using it again.
e. Dispose of the cloth after it is worn and use a new one. Place it in the holder and press the ends into
the 4 clips.
f. Press the holder into the interlocks at the bottom of the appliance and check for proper fit.
NOTE: You can also use commercially available cloths as a floor cloth. A screwdriver is supplied for easy
attachment of the floor cloth.
Problem
The appliance does not work.
The battery is not charged. The
green status indicator does not
flash.
The battery is not being charged.
The green status indicator
flashes.
Insufficient suction power.
Model Cleanfox
weight (netto)
Power Adaptor
Input power
Polatity
Batteries
Specification
Operating time
Charging time
Address:
Chal-Tec Vertriebs- und Handels GmbH, Wallstraße 16, 10179 Berlin

Troubleshooting

Possible Cause
The battery is not properly
connected.
The battery is not charged.
The appliance is not properly
connected to the adaptor and/or
the adaptor is not properly
connected to a mains power
supply.
Wall outlet is defective.
Adaptor is defective.
Adaptor is defective.
Nozzle is blocked.
Dust container is full.
Filter is dirty.
Floor cloth is dirty.

Specifications

1,85kg
AC 220-240V, 50/60Hz
12 x 1,2V, 800mAh
30 min. max.
6 h
Possible Solution
Connect the battery properly (see
chapter "Start-up").
Charge the battery (see chapter
"Start-up").
Connect the adaptor properly to
the appliance and
the wall outlet.
Try a different wall outlet.
Check your fuses.
Contact customer service.
Contact customer service.
Clean the nozzle.
Empty the dust container.
Clean the filter.
Clean or replace the floor cloth.