English - Braun Spin juicer SJ 3000 Typ 4290 Bedienungsanleitung

English

Read all use instructions thoroughly before
using this product.
Important
• This appliance shall not be used by
children. Keep the appliance and its
cord out of reach of children. Switch
off the appliance and disconnect from
supply before changing accessories or
approaching parts that move in use.
• This appliance can be used by persons
with reduced physical, sensory or
mental capabilities or lack of experience
and knowledge if they have been given
supervision or instruction concerning
use of the appliance in a safe way and
if they understand the hazards involved.
• This product is suitable for normal
household use only and not for com-
mercial use.
• Do not reach into the filling shaft while
the motor is running. Always use the
pusher to guide food through the shaft.
• Remove plug from socket before
assembling or disassembling appliance.
• Braun electric appliances meet
applicable safety standards. Repairs
or the replacement of the mains cord
must only be done by authorised
service personnel. Faulty, unqualified
repair work may cause considerable
hazards to the user.
Specifications
• Voltage/wattage: See typeplate on the bottom of
the appliance.
• Safety system: The appliance can only be
switched on when the cover has been fully locked
into position and can only be opened when the
switch has been turned off.
• Motor stop: The motor will stop completely within
2 seconds of switching the appliance off.
Safety fuse
If the appliance is overloaded the safety fuse will cut
out. To restart the appliance:
2
• Turn the switch off = «0» (important!).
• Unlock and remove the cover
5
• Clean the juice ring
• Allow the appliance to cool down approx.
20 minutes.
6
5722510024_SJ3000_P4-54.indd 6 5722510024_SJ3000_P4-54.indd 6
7
.
6 7
, filter and cover .
• Assemble the juicer again.
2
• Turn the switch on = «l».
• If the appliance still does not run, allow it to cool
down again.
Description
1
Motor part
2
On/off switch
3
Unlocking buttons
4
Pulp container
5
Juice ring
6
Filter
7
Cover
8
Filling shaft
9
Filling tray
0
Pusher
q
Juice spout
w
Juice container with foam separator
e
Cord storage
Before using for the first time, wash the juicer parts
(see «Disassembling» and «Cleaning»).
Assembling
5
1. Put the juice ring on the motor part
loosely without engaging).
6
2. Lay the filter into the juice ring
7
3. Put the cover on and push down firmly with
both hands until you hear it snap into place.
4. Hang the pulp container
top one first); then close it and be sure it snaps
into place.
5. Put the juice container
q
spout (A). Capacity: 500 ml. The juice container
comes with a foam separator to ensure clear
foam free juice.
If it is not required simply remove it from the juice
container. You can, of course, place a glass or
other container underneath the juice spout to
collect the juice.
6. For easier filling, put the filling tray
8
the filling shaft (A).
Preparing fruit or vegetables
Important: Use only well ripened fruits, otherwise
6
the filter may be clogged up which would result in
repeated cleaning of the filter. Wash or peel the fruit
or vegetables you want to process. Fruit with large
pips or stones should always have these removed
first. Process seed fruit (such as apples, pears) with
peels and cores. Fruit and vegetables with thick
peels (e. g. citrus fruits, melons, kiwis, beets) must
be peeled first. For grapes, cut off the main stem.
For leaf vegetables (e. g. cabbage and spinach)
and herbs, roll up leaves together tightly. Cut fruit
and vegetables into pieces large enough to fit into
the filling shaft.
Currants and rhubarb are not suitable for making
juice in the Braun spin juicer SJ 3000.
1
(fits
5
.
4
onto the hinges (the
w
underneath the juice
9
on top of
22.01.14 09:34 22.01.14 09:34