English - Braun Multiquick 5 Gebrauchsanweisung

English

Read all use instructions thoroughly before
using this product.
Important
• This appliance shall not be used by
children. Keep the appliance and its
cord out of reach of children. Switch
off the appliance and disconnect
from supply before changing
accessories or approaching parts
that move in use.
• This appliance can be used by
persons with reduced physical,
sensory or mental capabilities or lack
of experience and knowledge if they
have been given supervision or
instruction concerning use of the
appliance in a safe way and if they
understand the hazards involved.
This product is suitable for normal household
●
use only and not for commercial use.
● Do not reach into the filling shaft while the
motor is running. Always use the pusher to
guide food through the shaft.
Remove plug from socket before assembling
●
or disassembling appliance.
Braun electric appliances meet applicable
●
safety standards. Repairs or the replacement
of the mains cord must only be done by
authorised service personnel. Faulty,
unqualified repair work may cause
considerable hazards to the user.
Specifications
Voltage/wattage: See typeplate on the
●
bottom of the appliance.
Safety system: The appliance can only be
●
switched on when the cover has been fully
locked into position and can only be opened
when the switch has been turned off.
Motor stop: The motor will stop completely
●
within 2 seconds of switching the appliance
off.
Safety fuse
If the appliance is overloaded the safety fuse
will cut out. To restart the appliance:
2
Turn the switch
●
● Unlock and remove the cover
● Clean the juice ring
6
off = «0» (important!).
7.
5 6
, filter and cover
Allow the appliance to cool down approx.
●
20 minutes.
Assemble the juicer again.
●
● Turn the switch
● If the appliance still does not run, allow it
to cool down again.
Description
1
Motor part
2
On/off switch
3
Unlocking buttons
4
Pulp container
5
Juice ring
6
Filter
7
Cover
8
Filling shaft
9
Filling tray
j
Pusher
q
Juice spout
l
Juice container with foam separator
m
Cord storage
Before using for the first time, wash the juicer
parts (see «Disassembling» and «Cleaning»).
Assembling
1. Put the juice ring
(fits loosely without engaging).
2. Lay the filter
3. Put the cover
with both hands until you hear it snap into
place.
4. Hang the pulp container
(the top one first); then close it and be sure it
snaps into place.
5. Put the juice container
juice spout
container comes with a foam separator to
ensure clear foam free juice.
If it is not required simply remove it from the
juice container. You can, of course, place a
glass or other container underneath the juice
spout to collect the juice.
6. For easier filling, put the filling tray
of the filling shaft
Preparing fruit or vegetables
Important: Use only well ripened fruits, other-
wise the filter
would result in repeated cleaning of the filter.
Wash or peel the fruit or vegetables you want
to process. Fruit with large pips or stones
should always have these removed first. Pro-
cess seed fruit (such as apples, pears) with
peels and cores. Fruit and vegetables with thick
peels (e. g. citrus fruits, melons, kiwis, beets)
7
. must be peeled first. For grapes, cut off the
2
on = «l».
5
on the motor part
6
into the juice ring
7
on and push down firmly
4
onto the hinges
l
underneath the
q
(A). Capacity: 500 ml. The juice
8
(A).
6
may be clogged up which
1
5
.
9
on top