Bartscher 270 LN Bedienungsanleitung Seite 36

Setup
•
Place the device in a dry area with good ventilation.
•
Never place the device on a flammable surface.
•
Do not place the device near an open flame, electric oven or other source of heat,
as well as in direct sunlight. Heat may damage the device's surface and lead to
reduced efficiency.
•
To avoid damage to the compressor, during transport and setup do not tilt the
refrigerator further than 45° . Be careful in handli ng the condenser and door of the
device as damage to either element will result in problems using the device.
CAUTION!
Do not place nor use the refrigerator in unheated spaces nor on a balcony!
•
Do not place the refrigerator in areas with high humidity, as this may damage the
device and reduce its cooling output.
•
Do not cover or clog the ventilation openings at the top of the device.
Ensure free air circulation.
fig. 6
•
When required,adjust height by rotating the device feet. Rotating them clockwise lifts
the front side of the device, and rotating counterclockwise lowers it. When the
refrigerator is installed with a slight tilt backwards, the door close automatically.
- 34 -
•
Maintain a minimum of 10 cm
between the top of the device and
objects located above it (e.g. cup-
boards). Failure to do so may result
in increased energy use or overhea-
ting of the compressor (fig. 6).
•
When the device is placed in the
corner, leave at least 60 mm of the
side space (fig. 7).
•
Place the device on the even surface
so it does not touch the wall.
600(620)
fig. 7