Switching Off; Assembly; Replacing The Saw Belt; Disassembling The Saw Belt - EFA SB295E Originalbetriebsanleitung

Work instructions

The machine features a two-hand safety
circuit.

Hold the machine firmly at both switching
handles, never work one-handed.

Work particularly carefully when the
machine is switched on.

Protective equipment on the saw must not
be removed to complete cutting.

To aid safe handling (guidance), the saw
should be hung on a spring balancer.

After switching on the saw, never reach into
the area of the saw belt.

Do not actuate the motor switch when
installing the saw belt.

Check the suspension for damages
regularly.

Take heed of the general safety
instructions, see section "Safety
instructions".

4.2 Switching off


Lift your fingers off the switch lever.

The switch goes off automatically due to the
return spring and then locks.
When the splitting saw is switched off, the saw
belt stops moving immediately.

Assembly

5.
Disconnect the machine from
the mains before starting any
assembly work!
Assembly work may only be
carried out by authorised
specialist personnel.
Only use original EFA spare
parts!
Schmid & Wezel

5.1 Replacing the saw belt

The saw belt to be replaced only
if the units are disconnected
from the mains!
Never reach into the area of the
moving saw belt. Risk of cutting
off extremities!

5.1.1 Disassembling the saw belt


Open both lids (A) by their flaps (B) (each lid
has its own magnetic catch).

Loosen the saw belt by turning the Tightening
torque wrench (C) anti-clockwise.

This will slacken the saw belt.

Lift guiding implement and lever (D), push saw
belt out of the guides and take belt off the
wheels (see section "Saw belt guide").
C
Direction of saw belt
motion
D
A
B
Fig. 4: Replacing the saw
Lever D
up = working position
down = guide slackened for saw belt replacement
Page
44 of 72
belt
Version
11 / 2011