Switching Off; Handling; Work Instructions - EFA SB 322 E Betriebsanleitung

Mind to check the following points before
switching on the saw! This will help to almost
entirely avoid premature saw belt failures or
interruptions of the slaughtering process.
Prior to switching on, check if
 the belt saw is functional and
complete;
 the saw belt is properly installed;
 the water supply is correctly
connected and turned on;
 the suspension is correctly mounted
and fully operative;
 the guiding implements are spring
supported and able to move freely;
 a sharp saw belt has been installed
immediately before starting work (see
section "Mounting the saw belt");
 the general safety instructions are
obeyed (see section "Safety
instructions").
Both lids must be closed before you can
switch on the saw (safety lock-out).
Fig. 2 Switching on
If one switch is released during operation, you
will have to release both switches and actuate
them together again.
The two switches have
to be pressed
simultaneously (within
0.3 seconds).

3.2.2 Switching off

 Lift your fingers off the switch lever.
 The switch goes off automatically due
to the return spring and then locks.
When the splitting saw is switched off, the saw
belt stops moving immediately.
Schmid & Wezel
D-75433 Maulbronn

3.3 Handling

Never reach into the
area of the moving saw
belt. Risk of cutting off
extremities!
Improper use will result
in increased wear!
Wear eye protection or
safety goggles when
completing working!
Prior to use, check the mains supply,
transformer and unit for matching operating
data.
 Hold the splitting saw firmly with both
handles and switch on
 Move the saw into the carcass while in
operation.
 Remove from the carcass with the
saw still running, then release both
switch levers.

3.3.1 Work instructions

 The machine features a two-hand
safety circuit.
 Hold the machine firmly at both
switching handles, never work one-
handed.
 Work particularly carefully when the
machine is switched on.
 Protective equipment on the saw must
not be removed to complete cutting.
 To aid safe handling (guidance), the
saw should be hung on a spring
balancer.
 After switching on the saw, never
reach into the area of the saw belt.
 Do not actuate the motor switch when
installing the saw belt.
 Check the suspension for damages
regularly.
 Take heed of the general safety
instructions, see section "Safety
instructions".
Page
37 of 58
Version 1
07.2012