mild detergent (see also chapter
remove any components of the back of the appliance!
4. Install the appliance in a suitable position with an adequate distance from
sources of heat and cold.
5. If installation near a heat source is unavoidable, use a suitable insulation plate
or keep the following minimum distances to the heat source:
6. Check that the appliance and the power cord are not damaged.
7. Install the appliance in a dry and well-ventilated place.
8. Protect the appliance from direct sunlight.
9. The door(s) must open completely and without hindrance.
10.
Install the appliance on a level, dry and solid floor. Check the correct
installation with a bubble level.
11.
Connect the appliance to the mains properly.
12.
The rating plate is inside the appliance or at the back.
3.2 Space and ventilation requirements
Observe the required minimum distances for proper ventilation (s. chapter
3.2.1 W
ALL SPACERS
3.2.1 Wall spacers
The appliance is supplied with two plastic wall spacers
The installation of the wall spacers ensures a ventilation gap between the back
of the appliance and the wall. This allows proper ventilation as the back of the
appliance cannot be placed against the wall directly.
1. Insert the wall spacers in the corresponding openings on the back of the
appliance and tighten them.
2. Place the appliance against the wall with a minimum distance of 50 mm and a
maximum distance of 75 mm.
17
Depending on model
To electric cookers
To radiators or ovens
To another refrigerators at least 20 mm
and chapter 3.2.2 V
CLEANING AND MAINTENANCE
at least 30 mm
at least 300 mm
ENTILATION
52
). Never
).
17