Before First Use - SOLIS VARIO TEMP Bedienungsanleitung

CONTROL BUTTONS
▲ ▲
ON THE CONTROL PANEL
GB
a b
CO N TR OL BU TTO NS
▲ ■
a Temperature button 70°
b Temperature button 80°
c Temperature button 90°
d Temperature button 100°
e Warm-keeping button KEEP WARM
f ON/OFF button and quick start button to heat up to 100 °C
Note: every press of a button is accompanied by a signal tone.

BEFORE FIRST USE

▲ ▲
The kettle has to be cleaned prior to its first use. Proceed as following:
1. Place the unit base on a heat- and waterproof, clean, dry, solid and even work-
top close to a power outlet and out of the reach of children. Unroll the power
cord of the unit base completely and place it in a way that the appliance can
not be dragged down by the cord.
2. Take the kettle off the base and press the lid release button to open the lid.
3. Wipe the kettle´s and lid´s interior and exterior clean with a soft, damp cloth
and dry everything off.
4. Fill the kettle with cold tap water up to the MAX marking on the water display.
74
c d e f
Caution: The MAX marking in the kettle must never be exceeded, otherwise
boiling water might splash out! The maximum capacity is 1,7 litres. Likewise,
the MIN marking (0,5 litres) must never be undercut, otherwise the overheating
protection is triggered and the appliance automatically switches off.
5. Close the lid again by pressing it down until it snaps in. Caution: the lid must
always be closed during boiling.
6. If necessary, dry the outside of the kettle as well as the kettle bottom. Place the
kettle on the dry appliance base.
7. Connect the power plug to a suitable power outlet, the power cord has to be
completely unwound.
8. All control buttons light up briefly and then a two-time signal tone sounds while
all control buttons turn off, except for the temperature 100 °C button, which is
blinking blue, and the ON/OFF button which is lighting green. The blue blinking
temperature button and the green lighting ON/OFF button indicate that the
appliance is in standby mode.
9. Initially press the temperature 100 °C button and then the ON/OFF button to
heat up the water to 100 °C (or press solely the ON/OFF button to do a quick
start). During boiling the temperature 100 °C button lights up constantly blue
and the ON/OFF button lights red.
10. Wait until the water is boiling. At the end of the boiling process you will hear
a two-time signal tone and the control light of the ON/OFF button will light
green. The appliance will turn off automatically.
11. Pour the water carefully out the spout while keeping the lid closed.
12. Let the appliance cool down and then fill it again with cold tap water. To do
this open the lid and take the kettle off the unit base.
13. Afterwards put the filled kettle (with dry exterior) back onto the base and close
the lid.
14. Repeat the boiling process a second time and pour out the water again.
15. Your appliance is now ready to use.
GB
75