Herunterladen Inhalt Inhalt Diese Seite drucken

Hendi 230299 Gebrauchsanweisung Seite 9

Vorschau ausblenden Andere Handbücher für 230299:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 15
Control panel operation
Start of the washing program in glass rinser 230299 and dishwasher 230305
CONTROL PANEL FOR 230299
CONTROL PANEL FOR 230305
1. Open the main external water control valve and
press on the power safety switch dedicated to
the cup washer.
2. Make sure the tank filter "B" of the cup wash-
er has been properly placed in the bottom (see
figure opposite).
3. Make sure the overflow pipe "A" (overflow tube)
has been fitted properly (see figure opposite).
4. Turn on the cup washer by pressing the "ON/
OFF" button - the green "POWER" indicator
will light up - this means that the appliance is
powered on.
5. The cup washer tank starts filling with water
(on the first start-up of the appliance, the boiler
will start filling first).
6. When the tank is full, the boiler heater will
come on followed by the tank heater - this
is signalled by the lighting up of the orange
"TANK" indicators for the tank heater and
"BOILER" indicator for the boiler heater. The
heating time is about 30-40 minutes. Do not
start the washing cycle until the heater indica-
tors turn off - the water will not be hot enough.
7. When both the orange indicators turn off, put
the rack with crockery, close the washer's
door and start the washing cycle by pressing
and holding the "START" button down for 5
seconds. During the washing cycle, the green
"PROGRAM" indicator will remain lit. If the
"TANK" and/or "BOILER" indicator turns on
during the washing cycle, it is a normal event
and indicates the operation of the heater.
CAUTION: It is recommended to start subsequent washing cycles when the "TANK" and "BOILER" indica-
tors are off.
POWERH
EATING
PROGRAM
TANK
POWER
BOILER
PROGRAM
8. The full washing cycle lasts 2 minutes. It is
composed of 1 min. 40 sec. of the main wash-
ing with water heated to +62°C and of 20 sec.
of rinsing/scalding with water heated to +85°C.
9. When the washing cycle ends, the "PROGRAM"
indicator will turn off and the cup washer is
ready for another washing cycle.
10. To start another washing cycle, repeat the
steps from 7 to 9.
ON/OFF
ON/OFF
Correct insertion of baskets
START
START
EN
9

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

230312230305

Inhaltsverzeichnis