Hendi 230299 Gebrauchsanweisung Seite 10

Dishwasher 230305 has an additional component of
the control panel - a boiler water thermometer.
Start of the washing program in hood dishwasher 230312
1. Open the main external water control valve and
press on the power safety switch dedicated to
the cup washer.
2. Make sure the tank filter "B" of the cup wash-
er has been properly placed in the bottom (see
figure opposite).
3. Make sure the overflow pipe "A" (overflow tube)
has been fitted properly (see figure opposite).
4. Turn on the cup washer by pressing the "ON/
OFF" button - the green "POWER" indicator will
light up - this means that the appliance is pow-
ered on.
5. The cup washer tank starts filling with water (on
the first start-up of the appliance, the boiler will
start filling first).
6. When the tank is full, the boiler heater will come
EN
on followed by the tank heater - this is signalled
by the lighting up of the orange "TANK" indica-
tors for the tank heater and "BOILER" indicator
for the boiler heater. The heating time is about
40-50 minutes. Do not start the washing cycle
until the heater indicators turn off - the water
will not be hot enough.
7. When both the orange heater indicators turn off,
lift the hood - then the orange "DOOR" indicator
will light up - and put the rack with crockery
(see figure opposite), close the dishwasher's
CAUTION: When the hood is not closed properly, the dishwasher will not start; instead, the "DOOR" indicator
will light up.
Hood dishwasher 230312 has additional compo-
nents of the control panel - a boiler water ther-
mometer and a tank water thermometer. When the
10
When the dishwasher is operating correctly, the
thermometer reading should be +85°C (or more).
PROGRAM
DOOR
ON/OFF
door. The washing cycle will start automati-
cally when the hood is pulled down. During the
washing cycle, the green "PROGRAM" indicator
will remain lit. If the "TANK" and/or "BOILER"
indicator turns on during the washing cycle, it
is a normal event and indicates the operation
of the heater.
8. The full washing cycle lasts 2 minutes. It is
composed of 1 min. 40 sec. of the main wash-
ing with water heated to +62°C and of 20 sec.
of rinsing/scalding with water heated to +85°C.
9. When the washing cycle ends, the "PROGRAM"
indicator will turn off and the cup washer is
ready for another washing cycle.
10. To start another washing cycle, repeat the steps
from 7 to 9.
dishwasher is operating correctly, the boiler water
thermometer should read +85°C and the tank wa-
ter thermometer 62°C.
TANK
BOILER