Nilfisk-ALTO MAXXI WD 3 Betriebsanleitung Seite 8

THIS VACUUM CLEANER is designed, developed and rigo-
rously tested to function effi ciently and safely when properly
maintained and used in accordance with the following instruc-
tions. These instructions have been prepared with safety and
effi ciency paramount.
THE MACHINE OPERATOR must be trained by a suitably
qualifi ed instructor and must understand these instructions
for use, and be made aware of any relevant regulations and
legislation in force at the time of use.
CAUTION - This machine is not suitable for use in explosive
or infl ammable atmospheres or where such atmospheres are
likely to be produced by the presence of volatile liquid or infl am-
mable gas or vapour.
CAUTION - In no circumstances should the power supply cord be
wrapped around fi ngers or any part of the operators person.
CAUTION - The electrical supply plug must not be subjected
to undue stress by pulling on the power supply cord.
Your MACHINE must only be connected to an electrical supply
of the same voltage and frequency as indicated on the rating
plate. Ensure that the plug fi tted to the end of the power supply
cord is suitable for your supply socket, if not refer to the informa-
tion contained in 'Electrical Connections', or consult a qualifi ed
electrician. The electrical installation from which the supply
is drawn must be maintained to current Institute of Electrical
Engineers wiring regulations.
8
PLEASE READ THESE ESSENTIAL INSTRUCTIONS
(Only applicable to UK)
REGULAR SERVICING AND INSPECTION of your
machine must be carried out by suitably qualifi ed personnel in
accordance with relevant legislation and regulations. In particu-
lar, electrical tests for earth continuity, insulation resistance, and
condition of the fl exible cord should be checked frequently.
In the event of any defect, the machine MUST be withdrawn
from service, completely checked and repaired.
Trained Service Engineers will be pleased to carry out on site
servicing on a regular or as requested basis, to ensure the
continuing safety and effi ciency of your machine.