Testing And Maintenance - Jung RWM 100 WW Bedienungsanleitung

the included 6 mm anchor into the
hole. Now, push the included 5 mm
fl athead screw through the
underside of the magnetic mount
(fi g. 1 - III.) so that when the screw
is screwed into the anchor it is fl ush
with the magnetic mount. The
screw must be screwed fully into
the recess for this in the magnetic
mount (fi g. 1 - III.) to ensure a
secure hold! Please do not tighten
the screw so much, that the
magnetic mount deforms/buckles!

TESTING AND MAINTENANCE

This smoke alarm device checks its
operational readiness on its own,
once per minute. The device also
adjusts the sensitivity of its
detection optics automatically,
depending on the infl uencing
factors in its environment. When
the smoke detector begins to use
its energy reserves, or if the
detection optics are so dirty that
further readjustment is not possible
anymore, the device indicates
these conditions early on so that
you have ample time to replace the
smoke alarm device. Please be
very careful to ensure that the air
holes around the edge of the
smoke alarm device are never
impaired by dust, dirt, paint, or
tape, etc! You should press the test
and stop button (fi g. 1 - IV.)
regularly, but a minimum of once
per month, and thus trigger a test
signal, to ensure that the device is
operational. While doing this,
inspect the device to ensure it is
undamaged and fi rmly mounted in
place, and that the smoke intake
fi ns are completely free of foreign
particles. In the application
standard for smoke alarm devices,
DIN 14676, you will fi nd useful
directions for regular maintenance
and the selection of an optimum
installation location.
23