Commissioning; Installation; Adhesive Installation; Drilling Installation - Jung RWM 100 WW Bedienungsanleitung

22
are then well aired out; this will also
prevent renewed triggering of the
alarm.

COMMISSIONING

First remove any activation locks
(such as a cotter pin) and ensure
that the activation lock does not get
into the inside of the unit! Then
press the activation button (Fig.
1- I).
Press the activation button. After
pressing this button it must be fl ush
with the housing of the device. A
short test tone is sounded after
activation to verify that your smoke
alarm device is now activated. This
test tone is repeated when you
press the test and stop button (fi g.
1 - IV.) and serves as signal the
device is operational.

INSTALLATION

The smoke alarm device is held by
a magnetic mount (fi g. 1 - III.).
Described as follows, there are two
ways to attach the magnetic mount
to the ceiling. Please note that the
magnet attracts magnetically from
only one side.

Adhesive Installation:

When mounting the device using
adhesive, only use the adhesive
supplied with the product.
The area where the device is to be
mounted must be fi rm, dry and free
of grease, dust, loose coats of paint
etc. Remove the sticker and the
protective fi lm from the pre-applied
adhesive as shown in fi gure 2 and
press the magnet holder fi rmly onto
the area where the device is to be
mounted for around 10 seconds.
You can then mount the device
onto the magnet holder (fi g. 1,
no. III). The adhesive bond will
reach its fi nal strength after approx.
72 hours.

Drilling Installation:

At the location for installation drill a
hole using a 6 mm bit, and insert