Filling The Water Reservoir; Use - Cleanmaxx JC-232 Gebrauchsanleitung

Filling the Water Reservoir

PLEASE NOTE!
■ The water reservoir cannot be removed! To fi ll the water reservoir, use the measuring
cup that is also supplied!
■ Never pour any cleaning agent or additives into the water reservoir. This may destroy
the device and safe working is no longer guaranteed. Use distilled water or cold tap
water to fi ll it.
■ Do not overfi ll the water reservoir, fi ll it no higher than the MAX marking.
We recommend that you pour cold distilled water into the water reservoir (8) in
order to prevent calcifi cation, particularly if the tap water is very hard.

Use

PLEASE NOTE!
■ Use the device only if it has been fully and correctly assembled and the fl oor cloth has
been attached for cleaning fl oors.
■ Check the fl oor cloth for any wear before each use. Do not use the cloth if it shows
any signs of wear or if it is damaged. The fl ooring could be damaged.
■ CAUTION – Risk of scalding! After you switch off the device, hot steam may con-
tinue to emerge for a few seconds! Even after cooling, the water in the reservoir still
remains hot!
We recommend that, before using the device, you sweep the fl oor with a broom
or vacuum it using a vacuum cleaner.
1. Pull the fl oor cloth (12) over the cleaning foot (10) and pull the draw cord tight so that
it cannot slip off.
Use the carpet glider (11) that is also supplied to clean carpets. To do this,
place the carpet glider fl at on the carpet to be cleaned and place the clean-
ing foot with the fl oor cloth on the carpet glider.
2. Stand the device upright. The joint of the cleaning foot locks in place in a vertical
position.
3. Insert the mains plug into a properly installed plug socket that is easily accessible.
4. Move the On / Off switch (7) to the I position. The On / Off switch lights up when
the device is switched on. The device reaches operating temperature after around
20 – 30 seconds.
5. Press the handle rod down several times until steam emerges from the cleaning foot.
6. Hold the device by the handle (1) and tilt it slightly towards the fl oor to release the
locking of the cleaning foot.
01784_DE-EN-FR-NL_A5_V2.indb 17 01784_DE-EN-FR-NL_A5_V2.indb 17
17
1. Open the water reservoir cap.
2. Tilt the main unit (6) back slightly to make it easier to pour in
the water.
3. Use the measuring cup that is also supplied to pour cold, clean
water into the water reservoir (9) (note the MAX marking).
4. Close the water reservoir cap.
EN
02.02.2018 11:44:51 02.02.2018 11:44:51