Troubleshooting; Configuration; Default Settings - ABB A43 Installationshandbuch

EN

Troubleshooting

If any of the following icons,
installation has been completed and power has been connected to the
meter, refer to the A43/A44 User Manual for detailed information.

Configuration

To configure the meter and change the default settings, follow the in-
structions in the Configuration Guide at the end of this manual.

Default Settings

The following table lists the default settings of the meter that normally
needs to be changed. Check the settings to see if any of them needs to
be changed.
N
Note – For all other settings, including communication default
settings, refer to the A43/A44 User Manual.
Parameter
Clock
Ratios CT
Ratios VT
Pulse frequency
Pulse length
No. of wires
W C V
Direct connected
xxxxxx
----
---
100
100ms
4
9
, appear in the display after the
Transformer conn.
xxxxxx
1
1
10
100ms
4
EN