Lightmaxx Vega Matrix Wash Bedienungsanleitung Seite 20

Installation:
Always check the device for damage before use. Use the original packaging or suitable transport or
storage packaging to protect the product optimally from infl uences such as dust or moisture, etc.
when not in use.
The device can be installed either standing or hanging. The mounting must always be done on a
solid, approved support or an appropriate surface. Use the opening of the brackets to attach the
device. Always create a second, separate safeguard for the device, e.g. by means of a safety wire.
All work on the device (e.g. installation) should always be carried out from a stable and approved
platform. Make sure that the area below you is closed off.
Please note that the use of this device with a dimmer is not possible!
20
Warning! (Power Supply)
Make sure that the device voltage matches your local mains voltage. It is
strongly recommended to protect your mains socket with a residual current
circuit breaker (RCD).
If you do not use your device for a longer period of time, disconnect the device
from the mains to minimize dangers. The same applies to thunderstorms or
fl oods, etc.
Warning! (Risk of injury from falling)
It must be ensured that the device complies with all legal standards and regula-
tions in the respective country of use. Ensure that the device is always secured
by a second mounting cable (e.g. Safety).
Warning! (Overheating)
The maximum permissible ambient temperature of this device is 40° C. Ensure
that the unit is always adequately ventilated.
Warning! (Using Stands)
As soon as the device is mounted on a stand, a safe and fi rm base must always
be ensured. Ensure that the maximum permissible load capacity of your tripod is
not exceeded.
Warning! (Fault during data transmission)
Never connect the DMX input or output to audio devices such as power ampli-
fi ers or mixing consoles!
DMX cables enable interference-free operation and the highest possible trans-
mission reliability of signal data. Do not use microphone cables.