Renkforce 750782 Bedienungsanleitung Seite 50

Wiring example: Garage gate drive
+24 V GND
2
4
1 Control module
2 External voltage/current supply (24 VDC)
3 Aerial Module
4 For impulse input of the garage gate drive
5 PC for configuration
Observe proper connection of the connection lines (according to the description
of the garage gate drive) and whether the button as shown in the example
actually must be scanned to GND. Set the switching time of the relay to 0.5 s
so that you can switch the garage gate movement between „up" and „down"
quickly.
In the above wiring example, it is assumed that the garage gate drive works with
an operating voltage of 24 VDC. If this is not the case (see operating instructions
on the garage gate drive), you may need to use an additional mains unit for the
control module and a different wiring of the relay.
50
+12 V
GND
+24 V
Rel 1
Rel 2
RX TX GND
Ant 1
Ant 2
1
3
5