Functional Description - Renkforce 750782 Bedienungsanleitung

6. Functional Description

The product can control e.g. a door opener directly via the integrated relay and the
corresponding circuit.
Since the control module has a separate 24 VDC connection, a garage door can be
controlled as well (if it works with 24 VDC).
For wiring examples, see chapter 10.
A transponder can switch the relay in the control module on/off in „ON/OFF" mode. By
use of a transponder, an external button (the control module has a corresponding input)
or automatically after the end of the set switching time, the relay can be switched off
again.
Another option is using the product as a card reader. For this, you can install the aerial
module in the control unit (matching spacers are not included) and insert the enclosed
plastic side part with card slot.
There is a card guide on the inside of the housing top of the control module that permits
plugging in and holding the transponder card. In this configuration, the product is suitable
for permanent release of a connected device, since the relay is switched on for as long
as the transponder card is in the housing.
Selection of the suitable configuration (impulse mode, retrigger or fixed activation time
up to 127 minutes) permits leaving the relay and thus the connected device on for a freely
selectable time even after the card has been removed.
The event recording will always tell you who used the connected device via transponder
(and when).
In an internal EEPROM-memory, up to 500 transponder numbers with associated time
windows and 5000 reading events with date and time can be saved.
If a transponder with one off these saved numbers is recognised during recording of the
transponder data and if it is within a permitted time window, the reading module switches
the output (relay) and registers the process in the event memory.
Recognition of a transponder (even if it is not justified) is displayed via the LED on the
control module.
43