Albrecht Tectalk Smart XL Bedienungsanleitung Seite 27

Power on/off Button
Press and hold the POWER on/off button for at least 2
seconds. You will hear a confirming melody to indicate the
unit is on. To turn the unit off press and hold the button for
at least 2 seconds.
Monitor/Display Backlight Button
This button is used to check activity on the current frequency before
transmitting. Check activity by pressing the Monitor (M) Button longer
than 1 second; the icon (
hear static if the frequency is clear. Do not transmit if you hear a
conversation. Hold down the Monitor Button again longer than 1
second and the icon (
is also useful when communicating with other parties at extreme range.
By pressing the Monitor Button momentarily the LCD backlight is
turned on. The LCD backlight will be turned off automatically in about 5
seconds unless the Monitor Button is pressed momentarily once again.
Push-To-Talk (PTT) Button
Pressing and holding this button will allow you to speak to
any transceiver that is set to the same channel and privacy
code setting as yours. Hold the transceiver approximately
5-6 cm from your mouth as you speak into the built in
microphone. After you have finished speaking, release the PTT Button
to allow reception of incoming signals. Whenever the button is pressed
the transmit icon ( ) will appear. When receiving an incoming signal
the Busy (BUSY) icon will appear. The PTT button can also be used as
a two-way call ringer. Pressing the button twice quickly will call another
party on the same channel.
Up Button
In the standby mode pressing this button will increase the
listening volume. The current volume is indicated (1-7).
When in function edit mode this button will be used to adjust
) will appear on the display and you will
) will disappear from the display. This feature
7