Locomotive Configuration; Access To Locomotive Configuration; Delete Locomotives; Speed Step Configuration - Piko Navigator Bedienungsanleitung

4. Locomotive configuration

4.1 Access to locomotive configuration

You determine your locomotive s range of functions during locomotive configuration. This includes,
for example, the number of speed steps, the mode of operation, serial or parallel data processing or
the locomotive image.
Locomotive configuration is accessed b pressing and holding the key.

4.1.1 Delete locomotives

It is possible to delete unwanted locomotives in the first configuration window. The currently
selected locomotive is deleted by pressing .

4.1.2 Speed step configuration

After you have called up locomotive configuration, you will find yourself in speed step configuration.
Use to choose between and speed steps. D represents DCC
,
operation and M represents Motorola operation. Finally, confirm your selection using
In the case of MZS III, only 14+28 speed steps are possible.

4.1.3 Operational Data Mode

By selecting operational data transfer, it is possible to toggle between parallel transfer and serial
transfer using the key. Conform your selection using if you do not wish to also configure
the F key (see 4.1.4). The type of operational data transfer needed can be found in the description of
your decoder or locomotive.
5 1
35017-90-7000_2019_p40-76.indd 51 05.06.19 10:04