Bluetooth Mode; Troubleshooting; Cleaning And Care; Technical Data - Telefunken Rd1004 Gebrauchsanweisung

6. BLUETOOTH
Press the SOURCE (8) button until " Bluetooth
„
"BT Searching".
When the Bluetooth
„
Bluetooth
enabled device to pair with "RD1004".
®
You can now play music through Bluetooth
„
Use the VOLUME (2) control to adjust to your desired output level.
„
Rotate the TUNE/SELECT (12) control clockwise to go to the next song or counter-clockwise to
„
go to the previous song.
Press the TUNE/SELECT (12) control to Play/Pause the current song.
„
7. AUX MODE
Press the SOURCE (8) button until "Aux mode" is shown on the display (7) followed by "Aux Input".
„
Insert a 3.5 mm AUX cable (not included) into the AUX IN (15) socket at the back of the radio.
„
Connect the other end of the 3.5 mm AUX cable at your device.
„
You can now play audio through the Radio speakers.
„
Use the VOLUME (2) control to adjust to your desired output level.
„
8.

TROUBLESHOOTING

Problem
Appliance does not work.
The desired station is not found. Weak signal or the station is
The display (7) is empty.
Some stations are noisy.
No sound through the speakers. Volume is set too low.
Bad DAB/FM reception.
Appliance does not react to
pressed buttons / keys.
9.

CLEANING AND CARE

Pull the power adapter from the wall outlet before cleaning.
„
Clean the exterior with a lightly damp cloth.
„
Do not use harsh detergents.
„
Do not use chemicals (e.g. gasoline, alcohol) to clean the exterior.
„

10. TECHNICAL DATA

Power supply
Power supply via power adapter
Power adapter (supplied)
Input
Output
Power consumption
MODE
®
mode is activated, it will commence pairing. Follow the instructions on your
®
Possible cause
Power adapter (17) is not
connected properly..
not available in your area.
The broadcaster changes its
service or name.
Weak station signal.
The Telescopic antenna (16)
is not pulled out.
Malfunction due to
electrostatic discharge.
: 7.5 V
: 100-240V~, 50 / 60 Hz, 0.5 A MAX.
: 7.5 V
: 11 W
Mode" is shown on the display (7), followed by
®
.
®
Solution
Check if the power adapter (17) is properly
connected to the
back of the appliance and to a wall outlet.
Use the manual tuning for the station.
The appliance tries to set the station
again. If not successful, perform a new
scan for stations.
Adjust the DAB / FM antenna (16) again.
Increase the volume level.
Pull out completely and rotate the antenna
(16) for best reception.
Disconnect the appliance from the power
supply. Connect the power adapter (17)
again to a wall outlet.
1.5 A
, 1.5 A
20
DC 7.5V
inlet (14) at the
-
+