Thrustmaster TS-PC RACER Benutzerhandbuch Seite 11

AUTOMATIC RACING WHEEL CALIBRATION
The wheel automatically self-calibrates when you plug the racing wheel into an electrical outlet and
connect the racing wheel's USB connector.
During this phase, the racing wheel will rotate quickly towards the left and the right, covering a 1080
degree angle, before stopping at the center.
WARNING:
Never touch the racing wheel during the self-calibration phase!
(This could result in improper calibration and/or personal injuries.)
If your racing wheel does not function correctly, or if it seems to be improperly calibrated:
Power off your PC and completely disconnect the racing wheel. Then reconnect all cables (including
the power supply cable and the pedal set), and restart your PC and your game.
INTERNAL COOLING SYSTEM FOR THE WHEEL'S BASE
The internal cooling system for the wheel's base
- starts working when the wheel is powered on.
- switches off after a few minutes of inactivity when the internal temperature cools down to a low level.
- switches on again when you use the wheel.
MODE BUTTON AND INDICATOR LIGHT (6)
MODE button for the pedal set
You can electronically swap the accelerator and clutch pedals if you are using a Thrustmaster T3PA or
T3PA-PRO pedal set connected to the connector for pedal set (18).
To do so, simply press the MODE button (6) for 2 seconds.
The racing wheel's internal memory stores whether the pedals have been swapped around or not.
GAS AND CLUTCH PEDALS
Colour of the MODE indicator light (6)
NORMAL RED
SWAPPED AROUND GREEN
Other information regarding the MODE button
To learn more about the MODE button and indicator light, please visit
http://support.thrustmaster.com. Click Racing Wheels / TS-PC RACER, and then select Manual or
FAQ.
HELP FILES AND FAQS (NOT INCLUDED IN THIS MANUAL)
Please visit http://support.thrustmaster.com. Click Racing Wheels / TS-PC RACER, and then
select Manual or FAQ.
10/14