Hach RTC101 P Bedienungsanleitung Seite 9

Figure 5 Delete a sensor
1 Select sensor
2 Go back without changes
RTC input and output variables values
All input and output signals are connected to the sc1000 controller or directly to the RTC module.
Refer to the RTC module and the sc1000 documentation.
Refer to Table 2 and Table 3
Refer to Table 4, Table
Refer to Table 8 and Table 9
values.
Refer to Table 10 and
Refer to Table 12 for the RTC111 SRT-module measurement values.
Tag name Parameter Unit
RTC input PO
RTC input Flow rate
MEASUREMENT 1 Q 1
ACTUAT VAR 2 Pdos 1
ACTUAT VAR 3 Digi 1
ACTUAT VAR 4 Preg 1
ACTUAT VAR 5 ß' 1
ACTUAT VAR 6 Qras 1
Tag name Parameter Unit
RTC input PO
RTC input PO
RTC input Flow rate
RTC input Flow rate
for the RTC101 P-module measurement values.
5, Table 6 and Table 7
for the RTC113 ST-module and RTC112 SD-module measurement
Table 11 for the RTC103 N-module measurement values.
Table 2 RTC101 P-module (1-channel)
Channel Description
-P mg/L 1
4
L/s 1
L/s 1
L/h 1
— 1
L/h 1
— 1
L/s 1
Table 3 RTC101 P-module (2-channels)
Channel Description
-P mg/L 1
4
-P mg/L 2
4
L/s 1
L/s 2
3 Delete the sensor
for the RTC105 N/DN-module measurement values.
Phosphate
Supply volume flow
Wastewater flow rate
Set point precipitant dosing volume
Digital output for pulsed pump operation (ON/OFF)
Internal calculation variable for precipitant volume
Only with open loop: ß' otherwise internal calculation
variable.
Return sludge volume
Phosphate 1
Phosphate 2
Supply volume flow 1
Supply volume flow 2
English 9